Amplifier Research 150A400
| Attribute | Value |
|---|---|
| Frequency Range | 10 kHz – 400 MHz |
| Output Power | 150 Watts CW minimum |
| Gain | 55 dB minimum |
| Input Power for Rated Output | 0 dBm typical |
| Input Impedance | 50 Ohms |
| Output Impedance | 50 Ohms |
| Harmonic Distortion | -10 dBc maximum |
| Power Requirements | 220 VAC, 50/60 Hz, Single Phase |
| Cooling Method | Forced Air Cooling |
| Connector Type | Type N Female (Input and Output) |
| Model | 150A400 |
|---|
The Amplifier Research 150A400 Amplifier is a broadband, self-contained RF amplifier delivering 150 watts of swept power for demanding laboratory environments. Its push-pull MOSFET design ensures minimal distortion, enhanced stability, and safe operation into any load impedance. Featuring an integrated digital display, the unit provides real-time status updates and alerts on over-temperature, power supply, or amplifier faults. Controlled by an 8-bit RISC microprocessor, it offers precise digital operation with both IEEE-488 (GPIB) and full-duplex RS-232 interfaces for seamless local and remote control.
Ideal for RF susceptibility testing, antenna and component characterization, watt-meter calibration, and as a driver for higher-power amplifiers. Remote control and monitoring are supported via rear-panel GPIB, while a front-panel keylock ensures secure selection of local or remote operation modes.
Testwall can supply the used Amplifier Research 150A400 Amplifier, fully tested. With expert support and global delivery, Testwall ensures high-performance instrumentation with unmatched reliability and service quality. Please contact us directly if you need calibration or repair of the Amplifier Research 150A400 Amplifier.
