Sorensen
Sorensen DHP 6
0-50 60.0V Power Supply
0 – 6 V DC Ausgangsspannung
0 – 220 A Ausgangsstrom
1320 W Ausgangsleistung
115/230 V AC, 50/60 Hz Eingangssspannung
≤ 0,01 % + 2 mV Spannungsregelung (Lastregulierung)
| Attribut | Wert |
|---|---|
| Ausgangsspannung | 0 – 6 V DC |
| Ausgangsstrom | 0 – 220 A |
| Ausgangsleistung | 1320 W |
| Eingangssspannung | 115/230 V AC, 50/60 Hz |
| Spannungsregelung (Lastregulierung) | ≤ 0,01 % + 2 mV |
| Stromregelung (Lastregulierung) | ≤ 0,01 % + 2 mA |
| Restwelligkeit und Rauschen (Spannung) | ≤ 1 mV RMS |
| Restwelligkeit und Rauschen (Strom) | ≤ 5 mA RMS |
| Temperaturkoeffizient | ≤ 0,02 % / °C |
| Betriebstemperaturbereich | 0 °C bis +50 °C |
Sorensen DHP 6 Options:
- DHP - M1 - 360-440 VAC, 47-63 Hz, three phase, 3-wire plus ground, Delta or Wye may be used
- DHP - M2 - 432-528 VAC, 47-63 Hz, three phase, 3-wire plus ground, Delta or Wye may be used
- DHP - M8 - Internal RS-232 remote serial interface
- DHP - M9D - Internal IEEE-488.2 interface
- DHP - M10 - Both IEEE-488.2 and RS-232
- DHP - M11 - RS-232 and isolated analog programming
- DHP - M12 - IEEE-488.2 and isolated analog programming
- DHP - M14 - IEEE-488.2, RS-232 and isolated analog programming
- DHP - M51 - Isolated analog programming Input Voltage Options. This isolation allows users to control power supplies not connected to a common ground. In addition, in systems with high ambient noise or with large ground loop currents the control ground can be isolated from the power ground eliminating problems.
| Model | DHP |
|---|
