Amplifier Research 250S1G2z5A Microwave Amplifier : The Amplifier Research 250S1G2z5A is a self-contained, air-cooled, broadband, completely solid state amplifier designed for applications where instantaneous bandwidth, high gain and linearity are required. Housed in a single equipment rack, the 250S1G2z5A provides readily available RF power for typical applications, such as RF susceptibility testing, antenna and component testing, watt meter calibration, and as a driver for frequency multipliers and higher power amplifiers. A safety interlock can be implemented via a rear panel connector.  The 250S1G2z5A, when used with a sweep generator, will provide a minimum of 250 watts of RF power. Included is a front panel gain control which permits the operator to conveniently set the desired output level. The 250S1G2z5A is protected from RF input overdrive by an RF input leveling circuit which controls the RF input level to the RF amplifier first stage when the RF input level is increased above 0 dBm. The RF amplifier stages are protected from over-temperature by removing the DC voltage to them if an over-temperature condition occurs due to cooling blockage or fan failure. The Amplifier Research 250S1G2z5A is equipped with a Digital Control Panel (DCP) which provides both local and remote control of the amplifier. The DCP uses a color LCD touch screen and a single rotary knob to offer status reporting and control capability. The display provides Forward Power and Reflected Power values plus amplifier status. Special features include a gain control and RF output level protection. All amplifier control functions and status indications are available remotely in GPIB/IEEE- 488 format, RS232 hardwire and fiber optic, USB and Ethernet. The BUS interface connector is located on the back panel and positive control of local or remote operation is assured by a keylock on the front panel of the amplifier. The low level of spurious signals and linearity of the Amplifier Research 250S1G2z5A make it ideal for use as a driver amplifier in testing wireless and communication components and subsystems. It can be used as a test instrument covering multiple frequency bands and is suitable for a variety of communication technologies such as CDMA, WCDMA, TDMA, GSM etc. It is also suitable for EMC Test applications where undistorted modulation envelopes are desired. Functions and Specifications for the Amplifier Research 250S1G2z5A Microwave Amplifier Includes: RATED OUTPUT POWER: 250 watts minimum INPUT FOR RATED OUTPUT: 1.0 milliwatt maximum POWER OUTPUT @ 3dB COMPRESSION:Nominal, 275 watts;Minimum, 225 watts POWER OUTPUT @ 1dB COMPRESSION:Nominal, 200 watts;Minimum, 175 watts FLATNESS: ±1.5 dB typical, ±2.0 dB maximum FREQUENCY RESPONSE: 1.0-2.5GHz instantaneously GAIN (at maximum setting): 54 dB minimum GAIN ADJUSTMENT: Continuous Range, 4096 steps remote, 20 dB minimum INPUT IMPEDANCE: 50 ohms, VSWR 2.0:1 maximum OUTPUT IMPEDANCE: 50 ohms nominal MISMATCH TOLERANCE: 100% of rated power without foldback. Will operatewithout damage or oscillation with any magnitude and phaseof source and load impedance.  MODULATION CAPABILITY: Will faithfully reproduce AM, FM, or pulsemodulation appearing on the input signal. THIRD ORDER INTERCEPT POINT: 64 dBm typical NOISE FIGURE: 10 dB typical HARMONIC DISTORTION: Minus 20 dBc maximum at 175 watts SPURIOUS: Minus 73 dBc typical PHASE LINEARITY: ±1 deg/100 MHz, Typical PRIMARY POWER: 90-264 VAC, 50/60 Hz, single phase, 1300 watts maximum COOLING: Forced air (self-contained fans) EXPORT CLASSIFICATION: EAR99     

• Amplifier Research 250S1G2Z5A - Datasheet (115 Ko)