Amplifier Research 500W1000B Amplifier (Call for availablilty): The Amplifier Research 500W1000B is a self-contained, air -cooled, broadband, completely solid-state amplifier designed for applications where instantaneous bandwidth and high gain are required. Push-pull circuitry is utilized in all high power stages in the interest of lowering distortion and improving stability. The Amplifier Research 500W1000B, when used with an RF sweep generator, will provide a minimum of 500 watts of swept power.The Amplifier Research 500W1000B is equipped with a Digital Control Panel (DCP) which provides both local and remote control of the amplifier. The DCP uses a digital display, menu assigned softkeys, a single rotary knob, and four dedicated switches (POWER, STANDBY, OPERATE and FAULT/RESET) to offer extensive control and status reporting capability. The display provides operational presentation of Forward Power and Reflected Power plus control status and reports of internal amplifier status. Special features include a gain control, internal/ external automatic level control (ALC) with front panel control of the ALC threshold, pulse input capability and RF output level protection. Also included is an internal RF detector that provides an output for use in self-testing or operational modes. All amplifier control functions and status indications are available remotely in GPIB/IEEE- 488 format and RS-232 hardware, and fiber optic. The buss interface connector is located on the back panel and positive control of local or remote operation is assured by a keylock on the front panel of the amplifier. Housed in a stylish contemporary equipment rack the Amplifier Research 500W1000B provides readily available RF power for typical applications such as RF susceptibility testing, antenna and component testing, watt meter calibration, and use as a driver for higher power amplifiers. Functions and Specifications of the Amplifier Research 500W1000B Amplifier Includes: RATED OUTPUT POWER: 500 watts minimum INPUT FOR RATED OUTPUT: 1.0 milliwatt maximum POWER OUTPUT @ 3 dB compression: Nominal 575 watts, 525 watts min up to 500 MHz;475 watts min from 500 to 1000 MHz POWER OUTPUT @ 1 dB compression: Nominal 500 watts, 450 watts min up to 500 MHz;400 watts min from 500 to 1000 MHz FLATNESS: ±1.5 dB maximum; ±1.0 dB typical FREQUENCY RESPONSE: 80–1000 MHz instantane- ously GAIN (at maximum setting): 57 dB minimum GAIN ADJUSTMENT (continuous range): 25 dB mini- mum INPUT IMPEDANCE: 50 ohms, VSWR 1.5:1 maximum;1.3:1 typical OUTPUT IMPEDANCE: 50 ohms nominal MISMATCH TOLERANCE: 100% of rated power without foldback.Will operate without damage or oscillation with any magnitudeand phase of source and load impedance. MODULATION CAPABILITY: Faithfully reproduces AM, FM, orPulse modulation appearing on input signal. HARMONIC DISTORTION: Minus 20 dBc maximum at 400 watts,-20 dBc typical at 500 watts THIRD ORDER INTERCEPT POINT: 63 dBm typical NOISE FIGURE: 8 dB maximum, 6 dB typical PRIMARY POWER (specify voltage): 120-240 VAC, 50/60 Hz,single phase, 2200 watts     

• Amplifier Research 500W1000B - Datasheet (627 Ko)