The Microsemi 5125A Phase Noise and Allan Deviation (ADEV) Test Set with Ultra Low Noise Floor transforms the way these measurements are made. Traditional measurement instruments require an external phase-lock loop, turning these types of measurements into a complicated and costly endeavor. Compare this with the 5125A, which makes fast yet accurate single sideband (SSB) phase noise and ADEV measurements at the click of a button, all at a fraction of the cost of alternative solutions.
The 5125A employs both direct sampling of the RF waveforms as well as cross correlation, making it possible to easily characterize the highest performance time and frequency references. The third generation, all-digital 5125A has been designed to meet the most demanding requirements. The 5125A can measure phase noise down to -145 dBc/Hz at 1 Hz offset from a 10 MHz carrier and -130 dBc/Hz at 1 Hz offset from a 100 MHz carrier, making it the perfect solution to characterize the very low noise frequency references, such as those used in RADAR and satellite communications.
Microsemi's 5125A is the easiest to use phase noise and ADEV test set in the world: simply connect the device under test (DUT) and reference signal (which can be at a diffe frequency than the DUT) and press the 5125A's green Start button. Seconds later valid measurement data appears on the unit's high resolution display. With the all-digital 5125A, tedious multi-step configuration and calibration routines are no longer required.
The Microsemi 5125A provides phase noise measurement accuracy to previously impossible levels of ±1.0 dB. This combined with the best-in-industry phase noise and ADEV measurement floor means that with the 5125A you can characterize even your lowest noise references more accurately than ever before.
The 5125A is able to support the widest range of phase noise and ADEV measurements of any commercially available product. By converting the DUT and Reference signals to their digital representation as a first step, the patented all-digital design in the 5125A has eliminated the need for carrier suppression when making measurements, enabling phase noise measurements at smaller frequency offsets than previously possible (to below 0.1 mHz).
Features of the Microsemi 5125A include:
Simultaneous phase noise and Allan Dviation measurements
1 - 400 MHz input frequency range
No external data processing required
Industry leading accuracy
Allan Deviation measurements to over 300 days
Phase noise measurements as close as 0.1 MHz from the carrier
Displays internal noise estimate
Excellent phase noise measurements down to -170 dBc/Hz (typical) 10 kHz from the carrier (10 MHz input)
Jeśli nie jesteś całkowicie zadowolony z zakupu, po prostu zwróć produkt w oryginalnym stanie w ciągu 30 dni od daty otrzymania.
Zwracane przedmioty muszą być nieużywane i znajdować się w oryginalnym opakowaniu wraz z dołączoną dokumentacją. Po otrzymaniu dokonamy pełnego zwrotu kosztów, z wyłączeniem pierwotnych kosztów dostawy. Alternatywnie możemy wymienić produkt, jeśli wolisz.
VAT
Ceny nie zawierają VAT.
Transakcje wewnątrzwspólnotowe: Zgodnie z dyrektywą UE w sprawie VAT, sprzedaż towarów B2B pomiędzy krajami UE jest opodatkowana stawką 0%.
W przypadku naliczania VAT, stosowana jest stawka 23%.
Poza UE VAT nie jest naliczany.