Rohde & Schwarz FSH3
| Attribute | Value |
|---|---|
| Frequency Range | 100 kHz to 3 GHz |
| Resolution Bandwidth | 100 Hz to 1 MHz (in 1-3-10 steps) |
| Display Range | 100 dB |
| Reference Level Range | -20 dBm to +20 dBm |
| Phase Noise | < -80 dBc/Hz at 10 kHz offset |
| Input Impedance | 50 Ohm |
| Maximum Input Level | +20 dBm (continuous), 25 W peak |
| Battery Operating Time | Up to 3 hours with standard battery pack |
| Display | 6.5-inch color TFT LCD, 640 x 480 pixels |
| Weight | Approximately 3.3 kg (7.3 lbs) including battery |
Rohde & Schwarz FSH3 Options:
- FSH3 - FSH-B1 - Distance-to-Fault Measurement (includes 1 m cable, FSH-Z2 required)
- FSH3 - FSH-K1 - Remote Control via RS-232-C
- FSH3 - FSH-K2 - Vector Transmission and Reflection Measurements
- FSH3 - FSH-K3 - Receiver Mode
| Model | FSH3 |
|---|
The Rohde & Schwarz FSH3 is a portable spectrum analyzer available in 3 GHz or 6 GHz variants, with optional internal tracking generator. With the tracking generator, it supports DTF measurements, scalar/vector network analysis, and one-port cable loss measurement. Integrated preamplifiers enable accurate low-signal detection.
This device is ideal for field measurements, RF troubleshooting, and cable diagnostics. Optional power sensors allow precise terminating and directional power measurements up to 18 GHz and 4 GHz respectively.
Testwall can supply the used Rohde & Schwarz FSH3, fully tested. With expert support and global delivery, Testwall ensures high-performance instrumentation with unmatched reliability and service quality. Please contact us directly if you need calibration or repair of the Rohde & Schwarz FSH3.
