emtest
emtest HFK
Capacitive Coupling Clamp
Fluctuaciones rápidas de tensión (Flicker) Tipo de perturbación
0 V a 480 V (monofásico y trifásico) Rango de tensión de salida
50 Hz / 60 Hz Frecuencia de operación
Hasta 16 A (según configuración) Corriente máxima de salida
IEC 61000-4-11, IEC 61000-4-14, IEC 61000-4-28 Normas de cumplimiento
| Atributo | Valor |
|---|---|
| Tipo de perturbación | Fluctuaciones rápidas de tensión (Flicker) |
| Rango de tensión de salida | 0 V a 480 V (monofásico y trifásico) |
| Frecuencia de operación | 50 Hz / 60 Hz |
| Corriente máxima de salida | Hasta 16 A (según configuración) |
| Normas de cumplimiento | IEC 61000-4-11, IEC 61000-4-14, IEC 61000-4-28 |
| Interfaz de control | USB, GPIB, interfaz de software integrada |
| Tiempo de transición de tensión | Menos de 1 µs |
| Potencia nominal | Hasta 3 kVA (ampliable con unidades adicionales) |
| Dimensiones (An x Al x Pr) | Formato rack 19 pulgadas, 4U de altura |
| Temperatura de operación | 0 °C a 40 °C |
emtest HFK Options:
- HFK - CA EFT Kit - Calibration Kit for EFT Burst calibration includes: KW 50 50ohm load resistor, KW 1000 1,000ohm load resistor, AD-CA EFT Adapter 4mm/6mm to coaxial F103 connector (connection Load resistor to transducer plate)
- HFK - AD-CA EFT - Adapter to match the transducer plate to the KW 50 load resistor (connection Load resistor to transducer plate)
- HFK - KW 50 - Coaxial 50ohm load resistor for EFT/Burst transient calibration
| Model | HFK |
|---|
emtest HFK Capacitive Coupling ClampThe emtest HFK is used to couple EFT/burst pulses to I/O lines as required in diffe European and international standards for immunity testing. The coupling of the Electrical Fast Transients EFT/burst to signal lines can usually not be achieved by discrete capacitive coupling without interfering with the signal flow. It is often impossible to contact the required circuit (direct), e. g. coaxial or shielded cables. In this case the coupling is realized by the capacitive coupling clamp. The interference simulator can be connected on both sides of the coupling clamp.
Features of the emtest HFK include:Connects directly to the emtest UCS 500N5. And with adapters, it connects to the emtest NX5 Compact Immunity Tester Construction as per IEC 61000-4-4 Ed.3 EFT/Burst testing of signal- and datalines Active coupling length 1m Permissable burst voltage 7 kV For cable diameter up to 40 mm The HFK Capactive Coupling Clamp is identical to the emtest CCI Capacitive Coupling Clamp, except that it requires adapters to connect the NX5 without the need for adapters.
Features of the emtest HFK include:
